Products
Our Inventions
1) borin® - inside lathe tools
The tool-holder can be fixed in all usual collet chucks for diameter
10 mm. The changing of the tool-bits is done by hand, without any
further device.
The system-tools are suitable for bores more than
1 mm. The precision of our system tools and the special pick-up system
of our tool-holder has a repeatability of usually ± 10 µm. In most cases
it's not necessary to setup new axial and radial tool-positions. After
changing the tool-bits the height to center is always the same.
2) spinin® - brandnew for mass production
high performance drill
3) tourin® - thread whirler
PDF Download (6,8 MB)
